Page 1 of 1
Gearbox shimming - feeler gauges
Posted:
Thu Apr 19, 2018 1:08 pm
by al pushpak
hi, hope this doesn't sound like a daft question but where abouts should the feeler gauges be placed on the endplate when measuring the endfloat on the large gear shim ? thanks for any info
Re: Gearbox shimming - feeler gauges
Posted:
Thu Apr 19, 2018 3:53 pm
by Feersum Injun
Re: Gearbox shimming - feeler gauges
Posted:
Thu Apr 19, 2018 4:34 pm
by CHRIS in MARGATE
I always make sure the hub is torqued.
The way I was taught to measure in my apprenticeship was to make sure the feeler guage one size below passes and the feeler guage one size above doesn't pass.
Re: Gearbox shimming - feeler gauges
Posted:
Thu Apr 19, 2018 8:17 pm
by al pushpak
Thanks for the info & the pic , much clearer than the one in Sticky manual, cheers
Re: Gearbox shimming - feeler gauges
Posted:
Thu Apr 19, 2018 8:26 pm
by bazza3004
Does the feelef need to be inserted right up to the shaft as iirc isnt there a 'boss' under the bearing seat or does it only need to go in 10mm or so . Sorry if this sounds like a dumb question.
Re: Gearbox shimming - feeler gauges
Posted:
Thu Apr 19, 2018 10:45 pm
by Feersum Injun
I believe so.... the shim should rotate, hence the gap. Otherwise you'd be measuring from the shim to the plate and the gap would be way to big...
Re: Gearbox shimming - feeler gauges
Posted:
Thu Apr 19, 2018 10:47 pm
by Feersum Injun
Also make sure you use nuts and torque them unlike in my photo...!!!
Re: Gearbox shimming - feeler gauges
Posted:
Fri Apr 20, 2018 1:24 pm
by bazza3004
Thank you