LCGB Forums

Who makes/sells the rear view mirror that mounts through the pivot of the front brake lever?

Are they any good?

https://www.lambrettarestore.co.uk/

They are excellent Martin,

Rich'

They do tend to turn round in use, the temptation is to tighten them up but can stop the lever operating. I drilled down the side of the stud leaving a small stud like the woodruff key on the crank. A small cutout under the stud stops it turning round.

https://picclick.co.uk/Lambretta-Series ... id=1&pid=2

i have one like this i picked up off ebay & love it. much less intrusive than a long stalk but does take a bit of adjusting to get right

That is neat Mat, but I have gone with the other mirror, just because I can fit it and give the scooter back to the guy who owns it (and hopefully, get it out of my life forever)

However, next time.....

(And thanks Rich too)

I have them on my series 2 and silver special and they are good. The S2 brake lever housing must be thinner than the special's because if you overtighten the mirror the brake lever does not return. I have overcome the mirror movement by putting a tractor rocker cover copper washer under the mirror arm.

Tractorman
What is tractor rocket cover washer only ask as when I tighten mine I have the same issue?
Cheers Shane

shane BBoys wrote:Tractorman
What is tractor rocket cover washer only ask as when I tighten mine I have the same issue?
Cheers Shane

Presumably a washer on one of these


https://m.youtube.com/watch?ebc=ANyPxKp ... utuD_t6QkU

shane BBoys wrote:Tractorman
What is tractor rocket cover washer only ask as when I tighten mine I have the same issue?
Cheers Shane

Send me your address and I'll send you one.

Just noticed a tipo in my message, it's a rocker cover not rocket

Tractorman wrote:Send me your address and I'll send you one.

Nice one David. One man’s spare washer is another man’s life saver.

That is what this forum is all about.