Series 3 build Questions...
Posted: Thu Sep 30, 2021 1:19 pm
I have new legshelds , mudguard and horn cast on my current Li build...
Is it wise to pre-drill the legshield beading end caps (both ends) on the dry build? (Makes sense...missed this bit).
And the top end cap hole is so close to the edge of the legshield!! -Feels better to make it a slot then attempt drill a hole.
And when sitting the legshield to mudguard / horn casing seals in place has any one used a glue to help the seal profile stay in place on a painted surface? I was going to try some silicone gasket sealant to help keep the seals from moving.
Any pointers welcome -Cheers
JD
Is it wise to pre-drill the legshield beading end caps (both ends) on the dry build? (Makes sense...missed this bit).
And the top end cap hole is so close to the edge of the legshield!! -Feels better to make it a slot then attempt drill a hole.
And when sitting the legshield to mudguard / horn casing seals in place has any one used a glue to help the seal profile stay in place on a painted surface? I was going to try some silicone gasket sealant to help keep the seals from moving.
Any pointers welcome -Cheers
JD