Has anybody ever run a 22mm SH2 Dellorto through the S1 Framebreather set-up?
Just recently picked one up and wondering if it's at all possible as want the bigger carb on it, but ideally keeping it standard looking?
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
vegansydney wrote:Jon at Urban Scooters in Birmingham has a Framebreather with a S3 TV175 engine and he milled out the round 'F28' air intake to fit an SH1/20. It was done so well that I didn't even notice it until he pointed it out. He's a talented builder, friendly and super helpful. I'd recommend you reach out to him for advice.
I've also seen this at RLC, which is not exactly stock, but looks great.
vegansydney wrote:Just stumbled across this while searching for something else online. It's a GT186 and the engine was built by Nathan and Dez at DDS.
Those oversize hose clips would keep me awake at night though
Users browsing this forum: No registered users and 46 guests