LCGB Forums

The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com

Drive side oil seal plate

Technical help for Series one, two and three Lambrettas. Models include the Li, Li Special, TV, SX, GP, Serveta and API/SIL models

Drive side oil seal plate

Postby martyn dwane » Sun May 15, 2022 9:04 pm

Can anyone confirm the depth of the part where the oil seal sits, down to the small lip that stops the seal pushing right thru ?
Just purchased a new one and on fitting the seal it looked slightly proud, so i removed the seal and the depth im getting using a vernier is 5.54mm, measured by each screw hole.
The old plate measures 6.04mm.
thanks in advance .
martyn dwane
 
Posts: 371
Joined: Tue Jun 03, 2014 10:06 pm

Re: Drive side oil seal plate

Postby martyn dwane » Tue May 17, 2022 11:28 am

Phoned the Designer of these new seal plates and was told that the seal sits slightly proud to push a bit further into the bearing and hallite washer.
who knew !
martyn dwane
 
Posts: 371
Joined: Tue Jun 03, 2014 10:06 pm

Re: Drive side oil seal plate

Postby JETEX » Mon Jun 06, 2022 12:02 am

I have a good, original seal plate but I prefer to use the MB type. I also use the drive bearing with the extra seal.
JETEX
 
Posts: 569
Joined: Sat May 31, 2014 5:32 pm


Return to Series 1, 2 & 3

Who is online

Users browsing this forum: No registered users and 25 guests