Page 1 of 1

Drive side oil seal plate

PostPosted: Sun May 15, 2022 9:04 pm
by martyn dwane
Can anyone confirm the depth of the part where the oil seal sits, down to the small lip that stops the seal pushing right thru ?
Just purchased a new one and on fitting the seal it looked slightly proud, so i removed the seal and the depth im getting using a vernier is 5.54mm, measured by each screw hole.
The old plate measures 6.04mm.
thanks in advance .

Re: Drive side oil seal plate

PostPosted: Tue May 17, 2022 11:28 am
by martyn dwane
Phoned the Designer of these new seal plates and was told that the seal sits slightly proud to push a bit further into the bearing and hallite washer.
who knew !

Re: Drive side oil seal plate

PostPosted: Mon Jun 06, 2022 12:02 am
by JETEX
I have a good, original seal plate but I prefer to use the MB type. I also use the drive bearing with the extra seal.