Damaged Barrel
Posted: Wed Jul 19, 2023 11:43 pmI have a TV 175 cylinder with a fracture in the spigot.
Can it be welded and then machined?
Thanks.
Can it be welded and then machined?
Thanks.
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
http://www.ilambretta.co.uk/forum/
Damaged Barrel
http://www.ilambretta.co.uk/forum/viewtopic.php?f=10&t=15666
Page 1 of 1
Posted: Wed Jul 19, 2023 11:43 pmRe: Damaged Barrel
Posted: Thu Jul 20, 2023 9:34 amhow far up the spigot is the crack bud?
Re: Damaged Barrel
Posted: Thu Jul 20, 2023 6:12 pmAbout 3cm?
Re: Damaged Barrel
Posted: Fri Jul 21, 2023 1:30 amIf the crack veers off toward the periphery of the spigot then it's probably time to change it.
If it's more or less vertical, then it probably could remain servicable by drilling a hole through the spigot at the end of the crack to relieve the stress.
If it's more or less vertical, then it probably could remain servicable by drilling a hole through the spigot at the end of the crack to relieve the stress.
Re: Damaged Barrel
Posted: Fri Jul 21, 2023 8:41 am30mm, so that'd leave you about 25mm if you got it machined off upto the crack?
I have a TS1 barrel that's machined down cos of a cracked spigot.
the quatrini's don't have a spigot, so I'd have thought if you have 25mm of spigot then even for locating purposes its doin its job
I have a TS1 barrel that's machined down cos of a cracked spigot.
the quatrini's don't have a spigot, so I'd have thought if you have 25mm of spigot then even for locating purposes its doin its job