LCGB Forums

Before I go and drill my stand for one of these, has anyone tried one and got any feedback please?

Never seen one before, looks good, where’s it from?

Allstyles. They were advertised in Scooternova a few months back.

I think Sticky has made a clip on version, meaning you don't have to drill.
Available via ScooterNova: https://scooternova.com/shop/lambretta- ... %20process.

Nudger wrote:I think Sticky has made a clip on version, meaning you don't have to drill.
Available via ScooterNova: https://scooternova.com/shop/lambretta- ... %20process.

Correct he has great piece of kit.

Cheers Shane.

Nudger wrote:I think Sticky has made a clip on version, meaning you don't have to drill.
Available via ScooterNova: https://scooternova.com/shop/lambretta- ... %20process.

Yes. That was referred to in Scooternova too. The stand is out and will be going for paint soon. As it is going for paint, there’s no problem with drilling and it’s only a 5mm or 6mm hole needed. I suppose I am thinking that I may as well get it welded on anyway, or save it for an already painted stand

I completely missed that the stop was missing on my indian S2 stand and had it powder coated... Amazingly as soon as picked it up freshly coated i noticed it!!

I got my mate to turn me one in stainless, but i never made it like a clamp like them, just shaped the stop and bolted through.

Its been fine

I would have bought one of them

I’ve been putting off buying a small pillar drill for over twenty years. This prompted me to finally get one. Drilling holes in mild steel is now almost enjoyable

That looks mint

Storkfoot wrote:

I’ve been putting off buying a small pillar drill for over twenty years. This prompted me to finally get one. Drilling holes in mild steel is now almost enjoyable

Good job , love my pillar drill

When I think of the number and cost of drill bits and parts that I have wasted trying to use a hand held Black and Decker hammer drill, I could have bought the most hi tech power drill around