Rebuild Order

[Angry Bloke]

Hi - I'm just about to start my first Vega rebuild and was wondering if there was any preferential order or tips for reassembly - I had noticed that the bridge looked difficult to fit if the headset was on etc

a- Legshields
b- Cables / Loom
c- Forks
d- Bridge
e- Headset

Cheers

Peach

[coaster]

I have my note book open and a sharp pencil poised ready

[Angry Bloke]

I have my note book open and a sharp pencil poised ready

You may be poised for a while Colin,I'm not expecting to be inundated with replies but hopefully a few Luna line experts will give us there opinion

I've also posted this on the Luna forum

[coaster]

I might have exaggerated the 'poised' bit Peach, nowhere near stripping it yet

[Jim Rose]

Add a hammer in to your list mate

[Scooter Paul]

This is my rebuild order; stand, horn, legshields, forks with springs and links fitted, cables and loom, handlebar/headset (but don't tighten to forks, rear mudguard, front mudguard, engine, rear shock, rear wheel, front wheel, you can start to cable up but still don't fix handlebars to stem as you will have to lift it up to get the tunnel on. There is no kind way to say this; fitting the tunnel can be a 'mare. Some of the remade tunnel rubbers are just too thick and don't allow the tunnel to sit tight enough against the legshields. Good luck.
Paul.

[Angry Bloke]

Add a hammer in to your list mate

I have a special feather hammer for this build

[Angry Bloke]

This is my rebuild order; stand, horn, legshields, forks with springs and links fitted, cables and loom, handlebar/headset (but don't tighten to forks, rear mudguard, front mudguard, engine, rear shock, rear wheel, front wheel, you can start to cable up but still don't fix handlebars to stem as you will have to lift it up to get the tunnel on. There is no kind way to say this; fitting the tunnel can be a 'mare. Some of the remade tunnel rubbers are just too thick and don't allow the tunnel to sit tight enough against the legshields. Good luck.
Paul.

Cheers Paul