Page 1 of 1
luna 50 control lever washer question
Posted:
Sun Oct 02, 2016 2:11 pm
by grumpar
Hi i have a quite bad copy of a luna 50 manual showing 3 washers ? on the engine gear control lever i would imagine one is a oil seal with it going between the inside and outside of the engine but can anyone give more detail or post a detailed pic cheers
Re: luna 50 control lever washer question
Posted:
Mon Oct 03, 2016 1:28 pm
by 57Speedster
Hi, Not sure if Luna is exactly the same as other J Range, but there is a good parts book on here :
http://www.scooterhelp.com/serial/cento.parts.htmlMy Cento Gear selector shaft has 2 washers, and an O ring oil seal which fits in a groove at the top (lever) end of the shaft.
Re: luna 50 control lever washer question
Posted:
Mon Oct 03, 2016 4:37 pm
by grumpar
Thanks for the reply Speedster just what i needed, cheers
re Lui brass stealing lock
Posted:
Tue Oct 04, 2016 6:03 pm
by Bindog
Hi anybody ever taken a brass stealing lock out of a Lui ,it's side mounted type not the bolt on font one and its in the unlocked position I have no key thanks
Re: luna 50 control lever washer question
Posted:
Fri Oct 07, 2016 12:55 am
by mickey c
If it's like a vega lock, there are 2 square shims slid down the front of the lock, tap these out with something thin, the o'clock will come out if these are removed.