So I was changing bearings and lubricating them and when I mounted all back again I found myself with this clamp (see pictures!) not wanting to tight.. and I realised the thread inside is quite flat or there isn't any thread..Im lost here I don't know what to do and cant find this part on the internet =( I measured the diameter of the centre hole and is 30mm - 1/4 inches.
I have never used a rethreading tool and cant seem to find that size on internet... I really dont know what to do! if anyone recommends a tool I could use? or someone has a spare clamp that could sell?
Or if anyone knows where I could send the piece for rethreading? the other part seems fine as I put the two other pieces that go before that clamp and they are tight enough.
Thank you a lot in advance