Technical help for all early models, A, B, C, LC, D, LD, E & F models
by GianfraCh » Wed Mar 24, 2021 7:22 pm
Hi
Im curious if the 27mm nut in the crankshaft, flywheel side, is left hand or right hand? I know and have read that mag housing is sometimes very difficult to get out but I'm struggling even to get out the 27mm nut! Heh.
-
GianfraCh
-
- Posts: 102
- Joined: Wed Nov 18, 2020 5:27 pm
by GianfraCh » Wed Mar 24, 2021 7:53 pm
Update.. Managed to take the nut and the mag housing off too... Luckily wasn't too stuck.
-
GianfraCh
-
- Posts: 102
- Joined: Wed Nov 18, 2020 5:27 pm
by Steve J » Fri Mar 26, 2021 6:21 pm
For information, the only two left hand threaded nuts on the later LD machines are the one retaining the bevel gear on the crank, and the one retaining the splined clutch centre. (Early 125 machines had a right hand threaded nut on the clutch centre.)
-
Steve J
-
- Posts: 204
- Joined: Sun Jun 29, 2014 3:44 pm
- Location: Leicestershire
Return to Pre 57
Who is online
Users browsing this forum: No registered users and 1 guest