After reading good things about Threebond or Yamabond 1103 I decided to buy some to use on my current build to seal around the base packer (RT 195 with 60/110 crank) well what a load of complete and total shite! Cleaned and degreased the packer, smeared some of this shite on it first impression it looked like and smelled like grey primer, a few seconds after I applied it it dried to a dull grey colour and as I was handling the packer to slide down the cylinder studs the feckin stuff was coming off in lumps on my hands.
Enough was enough, I scraped the packer clean and used ht silicon instead so now I'm wondering what could have gone wrong? Bad batch, old stock? How do you boys get on with it?