Page 2 of 2

Re: Exhaust nickel plating

PostPosted: Wed Nov 07, 2018 2:15 pm
by Fast n Furious
Stainless definitely no good because of resonance differences as mentioned above.
Stainless welds are not very vibration resistant too.
Titanium might be a good choice? Bang goes the pension. :lol: :lol: :lol:

Re: Exhaust nickel plating

PostPosted: Fri Nov 09, 2018 1:42 pm
by burnside
Ceramic coating?

Re: Exhaust nickel plating

PostPosted: Fri Nov 09, 2018 3:34 pm
by Scooterdude
burnside wrote:Ceramic coating?

Difficult to repair if pipe splits....as ive found out first hand! Plus its mega expensive, as in as much if not more than a new exhaust!

Re: Exhaust nickel plating

PostPosted: Fri Nov 09, 2018 5:19 pm
by Solid Air
Also, the u-bend and tail-pipe on a clubby look crap after one winter's riding :x