LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
GT200 KIT
4 posts
• Page 1 of 1
GT200 KIT
by pinboy65 » Thu May 24, 2018 9:36 am
For those considering a GT200 KIT who may not be aware you will need to fit off set cones. I have a kit fitted to a 68 SX200 and the manifold has taken paint off my frame, on inspection virtually nil clearance and on the carb side the lower jubilee clip holding the M.B rubber mount has taken even more paint off! I have a very good quality rear shock so that not the issue....
- pinboy65
- Posts: 1
- Joined: Fri Oct 10, 2014 7:26 am
Re: GT200 KIT
by HxPaul » Thu May 24, 2018 10:17 am
How long is your rear shock? You will need one that is no longer than 300mm centre to centre.
-
HxPaul - Posts: 1583
- Joined: Fri May 30, 2014 9:18 am
- Location: Halifax
Re: GT200 KIT
by roli150lam » Sat May 26, 2018 8:42 am
There is also the option for a right hand side manifold.Which gives more clearance on the frame,less clearance carb to sidepanel with sx type panels.
My carb is on the left side,offset cones and 300mm shocker.It's close but not touching/rubbing the frame.
My carb is on the left side,offset cones and 300mm shocker.It's close but not touching/rubbing the frame.
- roli150lam
- Posts: 1354
- Joined: Fri May 30, 2014 8:16 pm
- Location: Lincoln
Re: GT200 KIT
by burnside » Sun May 27, 2018 10:37 pm
No issues with my GT200 kit in my TV200, PHBH30 on LHS
-
burnside - Posts: 987
- Joined: Mon Jun 09, 2014 10:39 pm
- Location: Flying 8 Balls - Norwich
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 9 guests