Page 1 of 1

Early li 125 gearbox on a ts1 ?

PostPosted: Sun Jun 10, 2018 9:48 pm
by al pushpak
Hi, just wondered is anyone is running one of these boxes on ts 225 with a bgm clubman exhaust & also what sprocket set up do you have ? thanks for any info ;)

Re: Early li 125 gearbox on a ts1 ?

PostPosted: Sun Jun 10, 2018 10:42 pm
by Norrie Bodge
I’d av thought 18x47 = 4.8 be best

Re: Early li 125 gearbox on a ts1 ?

PostPosted: Mon Jun 11, 2018 8:55 am
by soullad
^^^^
Yep, great box
Easier clutch life with bigger front sprocket, as per the 4.8 set up above
Great ratio in 1st esp if 2 up, luggage etc
Often unworn & cheap
Don’t tell everyone thou ;)

Re: Early li 125 gearbox on a ts1 ?

PostPosted: Tue Jun 12, 2018 5:13 pm
by lozmondo
Agreed.
I run 2 of them. 1 on a very revvy TS1 with a 16 tooth and the other on an RT195 with a 17.
Cost less than a third of what you pay for an LI150 box

Re: Early li 125 gearbox on a ts1 ?

PostPosted: Thu Jun 14, 2018 9:37 am
by al pushpak
thanks for your replies ;) what sprockets would you recommend for this gearbox ?full frame series 1, ts225, 30mm dellorto & bgm clubman & a 12 stone rider ! :) thanks again ;)

Re: Early li 125 gearbox on a ts1 ?

PostPosted: Thu Jun 14, 2018 3:40 pm
by soullad
18 x 47 would be a good starting point.

Re: Early li 125 gearbox on a ts1 ?

PostPosted: Sat Jun 16, 2018 6:26 pm
by al pushpak
Hi, guys, quick update , fitted the li 125 box today ,tried the 18x47 combo pulled great uphill but seem to run out of steam on the flat, put 17 X 46 combo on , much better ;) thanks again for your advice ;)