Page 1 of 1
JL3 end can on an NK?
Posted:
Sat Jan 13, 2024 9:26 pm
by ianmoran
Hello,
does anyone know if a JL3 end can will fit on an NK pipe? My NK can leaks a bit - loose rivet and there's a JL3 end can available.
Thanks
Re: JL3 end can on an NK?
Posted:
Sun Jan 14, 2024 2:09 am
by Fast n Furious
These end cans can usually be restored by drilling out any loose rivets and then repaired using new quality 3/16" steel pop rivets.
Re: JL3 end can on an NK?
Posted:
Sun Jan 14, 2024 12:41 pm
by ianmoran
ok, thanks. I might give that a try.
Re: JL3 end can on an NK?
Posted:
Fri Feb 02, 2024 1:31 pm
by corrado
Most bolt end cans are usually easily adaptable to fit other exhausts, either by elongating the holes on the mounting plate or drilling a new set of holes on the plate. The latter an option with 4 stud end can / plates. The one piece end cans / bracket type with rivet on end cans can be converted just by cutting the can off and drilling holes in the plate to accept a bolt on end can.