Page 1 of 1
Front sprocket touching case
Posted:
Wed Feb 07, 2024 11:19 pmby jdevane5
Just building an RT230 in a SIL GP150 & Looks like the front sprocket is just touching the inner case when assembled..
I've checked sprocket and all put together correctly.
Question is do I need to fettle the inner case? It's only just touching by a nats c...
It's a SIL case.
Cheers
JD
Re: Front sprocket touching case
Posted:
Thu Feb 08, 2024 12:14 pmby hullygully
fettle it, If you use a thicker dished washer then you'll have a knock on effect with the clutch alignement IMHO
Re: Front sprocket touching case
Posted:
Sat Feb 10, 2024 8:38 amby Covboy
Maybe a thicker gasket ?
Re: Front sprocket touching case
Posted:
Mon Feb 12, 2024 12:13 amby Knowledge
Are you saying that the top of the front sprocket stack is touching the inside of the chain case cover?
If so, then I would suspect an incorrectly assembled spring alignment. Try the hammer-test on the top of the spring retainer. If the hammer bounces, it is good. If it goes “clunk”, then take it apart and try again.
(Sorry if I have misinterpreted your OP)