hi,
Does anybody have any experience of fitting one of these bad boys to an S2 and the best way to route the hose ?
Cheers
MSB
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
ScootRS external disc on a Series 2
3 posts
• Page 1 of 1
ScootRS external disc on a Series 2
by Madstadblues » Fri Feb 27, 2015 11:03 am
- Madstadblues
- Posts: 13
- Joined: Tue Jun 10, 2014 8:40 pm
Re: ScootRS external disc on a Series 2
by Digger » Fri Feb 27, 2015 1:55 pm
Not an RS disc but the principle is the same.
Hole through the headset and route where the cable would have gone. This actually has matching grooves in top and bottom halves.
Hole through the headset and route where the cable would have gone. This actually has matching grooves in top and bottom halves.
-
Digger - Posts: 992
- Joined: Sat May 31, 2014 4:41 am
- Location: Stroud, Gloucestershire
Re: ScootRS external disc on a Series 2
by Madstadblues » Fri Feb 27, 2015 2:00 pm
Lovely looking bike!
I'm currently disassembling the headset to get the hose fitting through the gap between the headset and headset bracket and wanted to make sure I was on the right lines.
Cheers
MSB.
I'm currently disassembling the headset to get the hose fitting through the gap between the headset and headset bracket and wanted to make sure I was on the right lines.
Cheers
MSB.
- Madstadblues
- Posts: 13
- Joined: Tue Jun 10, 2014 8:40 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: Bing [Bot] and 17 guests