LCGB Forums

The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com

stator plate

Technical help for Series one, two and three Lambrettas. Models include the Li, Li Special, TV, SX, GP, Serveta and API/SIL models

stator plate

Postby bricky36 » Mon Jun 08, 2015 4:05 pm

Going to fit gp crank in my li125 engine, I know I need gp flywheel, but can I fit a gp stator plate?
or does it have to be a Li stator plate, is there a difference?


Thanks
bricky36
 
Posts: 66
Joined: Sat Jun 07, 2014 6:31 pm

Re: stator plate

Postby Captain Pugwash » Mon Jun 08, 2015 4:14 pm

GP stator should be fine on the li flywheel and crank just check the centre hole is wide enough for the LI boss to fit inside.

GP stators have a bigger centre hole in the middle than early LI ones but sometimes they are a tight fit because it might not be the later type GP stator that you think you have.

But if your running an early Brass type flywheel it will be fine whichever 6 pole Ducati stator you fit.
User avatar
Captain Pugwash
 
Posts: 422
Joined: Fri May 30, 2014 7:48 pm
Location: Liverpool

Re: stator plate

Postby bricky36 » Mon Jun 08, 2015 4:22 pm

So if was going to fit a gp electronic flywheel kit, it would fit ok on li engine with gp crank?



Thanks
bricky36
 
Posts: 66
Joined: Sat Jun 07, 2014 6:31 pm

Re: stator plate

Postby Captain Pugwash » Mon Jun 08, 2015 4:27 pm

Yes if you are changing the crank and flywheel and fitting the GP electronic kit that's the best way to do it IMO.
User avatar
Captain Pugwash
 
Posts: 422
Joined: Fri May 30, 2014 7:48 pm
Location: Liverpool

Re: stator plate

Postby bricky36 » Mon Jun 08, 2015 4:30 pm

Excellent, thank you.
bricky36
 
Posts: 66
Joined: Sat Jun 07, 2014 6:31 pm


Return to Series 1, 2 & 3

Who is online

Users browsing this forum: No registered users and 26 guests