For some reason my series 2 Li150 has a knackered looking SH1/18 carb rather than the standard MB19 BS7. Does anybody know if these two carbs fit the same inlet manifold?
I put this question in the Carburettors forum so apologies if either of these posts is in the wrong place!
Cheers
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
SH1/18 carb on a series 2
3 posts
• Page 1 of 1
SH1/18 carb on a series 2
by 507VBH » Sun Jan 10, 2016 10:28 pm
- 507VBH
- Posts: 92
- Joined: Wed Dec 02, 2015 10:10 pm
Re: SH1/18 carb on a series 2
by 507VBH » Thu Jan 14, 2016 9:31 pm
The two carbs have a 27.5mm clamping diameter.
- 507VBH
- Posts: 92
- Joined: Wed Dec 02, 2015 10:10 pm
Re: SH1/18 carb on a series 2
by Ivor the engine » Tue Jan 19, 2016 1:25 pm
Hi,
As long as you have the longer inlet manifold for the series 2, (a shorter series 3 inlet will have the carb snagging the fuel tap lever).
I'm doing a similar changeover, all seems well with fitment.
Regards,
Ivor.
As long as you have the longer inlet manifold for the series 2, (a shorter series 3 inlet will have the carb snagging the fuel tap lever).
I'm doing a similar changeover, all seems well with fitment.
Regards,
Ivor.
-
Ivor the engine - Posts: 18
- Joined: Tue Jul 15, 2014 9:50 pm
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 19 guests