Would brazing work? PS panel does actually fit
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
Panel repair??
3 posts
• Page 1 of 1
Panel repair??
by DaveTomo » Mon Aug 08, 2016 8:57 pm
Any idea if this is repairable? Back end of a SX panel , looks like its been cut as opposed to broken Would brazing work?
PS panel does actually fit
Would brazing work? PS panel does actually fit
- DaveTomo
- Posts: 179
- Joined: Fri May 30, 2014 6:24 pm
Re: Panel repair??
by Digger » Mon Aug 08, 2016 9:00 pm
Anything is repairable - you just need to find someone with the necessary skills.
Can't see anything too tricky there.
Can't see anything too tricky there.
Last edited by Digger on Tue Aug 09, 2016 5:53 am, edited 1 time in total.
-
Digger - Posts: 992
- Joined: Sat May 31, 2014 4:41 am
- Location: Stroud, Gloucestershire
Re: Panel repair??
by xenia1 » Mon Aug 08, 2016 9:09 pm
^
As Digger says
Strip it back to bare metal as it looks as though theres some filler in there as invariably the hole will be bigger than it looks at the moment. Any competant welder should be able to fabricate a small section and butt weld it in place, once ground back the repair should be pretty much invisible.
Andy
As Digger says
Strip it back to bare metal as it looks as though theres some filler in there as invariably the hole will be bigger than it looks at the moment. Any competant welder should be able to fabricate a small section and butt weld it in place, once ground back the repair should be pretty much invisible.
Andy
-
xenia1 - Posts: 1375
- Joined: Mon Jun 02, 2014 7:53 pm
- Location: Malaga Espana/ Norwich UK.
3 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 11 guests