series 1 SIP speedo plus ignition switch - does it fit?

[bike grim]

As above, I would appreciate any help in the form of pictures if any kind soul on here has successfully fitted both. There's not a lot of room in there. The routing of the wiring is the main obstacle. Fitting standard speedo and ignition switch is fine. And also standard kill button with SIP speedo is fine.
Thanks
Gareth

[bike grim]

Nobody tried this previously then?

[Marty ULC]

Hope so, I'm wanting the same set up on my series1.

[modster79]

I fitted a SIP and ignition key, I had to enlarge the holes where the cables enter from the headstock to the horncover. Still a tight fit getting the plug ends through. I personally don't think SIP thought it out towards fitting to a series one, to much hassle and to messy looking for me. Would post photos but went back to standard speedo.

[bike grim]

Mmm ....think I'll stick with kill button and fit the SIP