LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
legshield badge positioning
24 posts
• Page 2 of 2 • 1, 2
Re: legshield badge positioning
by Wack » Fri Nov 27, 2015 10:10 pm
I contacted Casa Lambretta and asked if they had thought of a poster and they said they will consider it, although they said Rimini LC is possibly going to do something similar.
- Wack
- Posts: 737
- Joined: Sat May 31, 2014 7:11 pm
Re: legshield badge positioning
by byron » Tue Dec 01, 2015 7:59 pm
did this today, bit of a ballache, luckily Olly was round to hold things and offer an opinion.
nothing wrong with Russ' measurements [they matched a GT200 I have in], but repo legshields didn't have holes in the same places... had to enlarge them to enable the horn casing to fit... and the new badges may not be the best quality, so they didn't necessarily have the same pin spacings either... I did it by eye in the end... should be fine...
nothing wrong with Russ' measurements [they matched a GT200 I have in], but repo legshields didn't have holes in the same places... had to enlarge them to enable the horn casing to fit... and the new badges may not be the best quality, so they didn't necessarily have the same pin spacings either... I did it by eye in the end... should be fine...
-
byron - Posts: 171
- Joined: Sun Jun 08, 2014 3:09 pm
- Location: norwich
Re: legshield badge positioning
by carlos fandango » Fri Apr 17, 2020 9:12 am
Paul "Sheep sheep shagger" Todd !
- carlos fandango
- Posts: 244
- Joined: Fri May 30, 2014 12:01 am
Re: legshield badge positioning
by Toddy » Fri Apr 17, 2020 7:45 pm
carlos fandango wrote:Paul "Sheep sheep shagger" Todd !
-
Toddy - Posts: 10158
- Joined: Tue May 13, 2014 9:58 pm
- Location: East Yorkshire
24 posts
• Page 2 of 2 • 1, 2
Who is online
Users browsing this forum: Bing [Bot] and 19 guests