LCGB Forums

I have a few stators that I want to renovate.
What grade of connecting wire should I use? Current, diameter?
Also do people just use araldite epoxy to overcome vibration?
Any recommendations for suppliers?

AlG

http://www.vehicle-wiring-products.eu/

Are always good for electrical components.

Wire rated for 10-15amps is probably sufficient

I just use these

http://www.scooterrestorations.com/lamb ... on-system/

gaz_powell wrote:I just use these

http://www.scooterrestorations.com/lamb ... on-system/

+1

Good deal those.

rossclark wrote:http://www.vehicle-wiring-products.eu/

Are always good for electrical components.

Wire rated for 10-15amps is probably sufficient

+1

Many thanks all. I have used the SR kits in the past, but when doing an electronic DC conversion you need an extra yellow - agreed they are good value though.
Just ordered a range of wire and black shielding tube from Vehicle-Wiring-Products for £10 that should allow me to do three stators, so pretty much the same as SR

AlG