LCGB Forums

Morning.
Do the series 3 cut off / shortened runners fit a series 2 ? If not who’s supplying series 2 aluminium or fibreglass?

Shane

Try here for fibreglass m8

http://www.grpscooterparts.co.uk/

Norrie Bodge wrote:Try here for fibreglass m8

http://www.grpscooterparts.co.uk/

Ta,

S3 cut off/shortened rear runners won't fit S2.

I've seen plenty of S3 one off the shelf, but when I wanted a set for S2 I had to make them.

gaz_powell wrote:S3 cut off/shortened rear runners won't fit S2.

I've seen plenty of S3 one off the shelf, but when I wanted a set for S2 I had to make them.

Gaz.
Thanks for the heads up, ill speak to Chris as i am doing everthing i can in fibre glass, arse about face as per usual have the engine, in bits of caurse: frame & forks and panels ( fibre)

Shane.

Easy answer is cut down a set of F/G ones and get Chris to edge them (what I should have done) it's an expensive route but they will look good, I was never happy with my flat sheet metal ones bent (like off the shelf S3).

Are you still after S2 panel badges in vinyl....
viewtopic.php?f=19&t=86&p=300&hilit=S2+bitsa#p300

gaz_powell wrote:Easy answer is cut down a set of F/G ones and get Chris to edge them (what I should have done) it's an expensive route but they will look good, I was never happy with my flat sheet metal ones bent (like off the shelf S3).

Are you still after S2 panel badges in vinyl....
viewtopic.php?f=19&t=86&p=300&hilit=S2+bitsa#p300

Contacted chris with great success. Yes I am still after some.

Cheers Shane.