Page 1 of 1
S2 headset space
Posted:
Fri Dec 28, 2018 11:28 pmby Stesjh
Looking for a bit of advice. Currently building a S2 and have noted there is limited space in the headset for additional cables and wiring. Try to add hydraulic cable and wiring plus thumb choke. Is it me or is there a lot less space compared say to a GP? Any solutions would be most welcomed.
Re: S2 headset space
Posted:
Fri Dec 28, 2018 11:32 pmby CHRIS in MARGATE
Removing the front brake cable will help.
Re: S2 headset space
Posted:
Sat Dec 29, 2018 9:58 amby Norrie Bodge
Loads of room
I run hydraulic/thumb choke/CHT & Rev counters
Re: S2 headset space
Posted:
Wed Jan 02, 2019 4:20 pmby Stesjh
Norrie Bodge wrote:Loads of room
I run hydraulic/thumb choke/CHT & Rev counters
Did you have to modify anything?
Re: S2 headset space
Posted:
Thu Jan 03, 2019 7:20 amby Toddy
I run similar to Norrie heres how ,
Thumb choke runs through Hole in the headset bottom along side the hgeadset clamp bolt
Clutch cable normal route
Hydralic disc cable comes up at the Front of the headset with a small fettle to allow movement
Wiring loom and extras come up the side of the gear wheels
i also have an ignition in mine as well
Hope this helps Toddy
Re: S2 headset space
Posted:
Thu Jan 03, 2019 8:50 pmby shane BBoys
Toddy wrote:I run similar to Norrie heres how ,
Thumb choke runs through Hole in the headset bottom along side the hgeadset clamp bolt
Clutch cable normal route
Hydralic disc cable comes up at the Front of the headset with a small fettle to allow movement
Wiring loom and extras come up the side of the gear wheels
i also have an ignition in mine as well
Hope this helps Toddy
Paul do you have a couple of photos as they may come in handy for my ongoing project?
Cheers Shane
Re: S2 headset space
Posted:
Thu Jan 03, 2019 11:45 pmby Toddy
Paul do you have a couple of photos as they may come in handy for my ongoing project?
Cheers Shane[/quote]
Here you go buddy not finished yet but shows what you need
Re: S2 headset space
Posted:
Sun Jan 06, 2019 5:26 pmby Stesjh
Many thanks for the pictures, very helpful
Re: S2 headset space
Posted:
Mon Jan 07, 2019 8:01 amby Norrie Bodge
Norrie Bodge wrote:Loads of room
I run hydraulic/thumb choke/CHT & Rev counters
heres mine they may help
Re: S2 headset space
Posted:
Mon Jan 07, 2019 10:15 amby Tractorman
You will make more room if you remove the wiring junction block.
Re: S2 headset space
Posted:
Mon Jan 07, 2019 10:18 amby Toddy
Tractorman wrote:You will make more room if you remove the wiring junction block.
Agreed I’ve had to do that to fit my jockeys headlight
Re: S2 headset space
Posted:
Mon Jan 07, 2019 1:47 pmby foremanbob
Stesjh wrote:Looking for a bit of advice. Currently building a S2 and have noted there is limited space in the headset for additional cables and wiring. Try to add hydraulic cable and wiring plus thumb choke. Is it me or is there a lot less space compared say to a GP? Any solutions would be most welcomed.
How about going left field and fitting a remote hydraulic master... can thoroughly recommend the Oiltek unit that mounts under the floor on the LHS of the scoot.
Lovely bit of kit