Page 1 of 1

Gears and Clutch issue

PostPosted: Sun Sep 08, 2019 1:27 pm
by Danbretta
Hi all,
I've got a problem with my clutch not working properly. I've installed a new clutch followed the manual (soak in oil, check clearance etc). This has been in the scooter probably about a year now . Ive only found the time to carry on with the restoration. Side case has gone back on and oil put in.

Problem is I can select gears ok but while still holding the clutch in the scooter wont roll. It locks up on the gears, also i can change gear at a standstill without pulling the clutch.?

I'm sure I followed all instructions to the manual. This was probably at the back end of last year now, would sitting for a while dry out the clutch and gearbox as its had no oil sitting in it.

I'm fearing it's a strip down again unless theres an easy fix from the cable end?

Any thoughts before I get stuck in are much appreciated.

Re: Gears and Clutch issue

PostPosted: Sun Sep 08, 2019 1:37 pm
by rossclark
The plates can stick together if left for a while - usually a few kicks will free then off.

Try kicking it over and pulling the clutch lever in and out to see if it binds / slips.

Re: Gears and Clutch issue

PostPosted: Sun Sep 08, 2019 2:38 pm
by Danbretta
Thanks Ross,
I'll give it a try. I've kicked it over a few times, I'll let the oil soak over and see if that loosens the plates.
Would that make it possible to flick through the gears without using the clutch or would it be a worn selector?

Re: Gears and Clutch issue

PostPosted: Tue Sep 10, 2019 12:31 pm
by Danbretta
All good for now, the plates seem to be free and clutch working.
As you say they have probably stuck due to be sitting for a while..

Thanks for your help. I was on the verge of draining the oil and taking the side off. I did srop a horoscope on through the breather plug and have a look to see what was going on. Handy piece of kit for £20+ saved a few hours work for nothing.