Page 1 of 1
Series 2 horn
Posted:
Thu Apr 02, 2020 9:21 amby shane BBoys
Just noticed that the stub, bolt for the horn is missing or cut off at some point I’m guessing I can centre punch drill and tap it what size tap would be required.
Cheers Shane.
Re: Series 2 horn
Posted:
Thu Apr 02, 2020 3:25 pmby Norrie Bodge
shane BBoys wrote:Just noticed that the stub, bolt for the horn is missing or cut off at some point I’m guessing I can centre punch drill and tap it what size tap would be required.
Cheers Shane.
Drill & Tap to m6
Re: Series 2 horn
Posted:
Thu Apr 02, 2020 5:50 pmby shane BBoys
It just taken me an hour to find my tap n die set, I thought it was in the conservatory where I’d last used it but no it was in the garage on top of the over spill ( beer ) fridge, so will sort it tomorrow between painting some bits for this build.
Cheers Shane.
Re: Series 2 horn
Posted:
Fri Apr 03, 2020 7:31 amby gaz_powell
My API S2 never had anything. Just drilled and tapped frame and put a spot weld on it for good measure
Re: Series 2 horn
Posted:
Fri Apr 03, 2020 6:47 pmby shane BBoys
gaz_powell wrote:My API S2 never had anything. Just drilled and tapped frame and put a spot weld on it for good measure
I’ve drilled and taped the square plate where the stub- bolt must have been, the frames already powder coated so welding is not and option.
Cheers Shane.