Kick Start Bushes
Posted: Sun Apr 26, 2020 5:20 pmGuys.
How can I remove this please?
Cheers Shane.
How can I remove this please?
Cheers Shane.
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
https://www.ilambretta.co.uk/forum/
Kick Start Bushes
https://www.ilambretta.co.uk/forum/viewtopic.php?f=10&t=12657
Page 1 of 1
Posted: Sun Apr 26, 2020 5:20 pmRe: Kick Start Bushes
Posted: Sun Apr 26, 2020 5:49 pmRun a hack saw blade till you are just about through then they should tap out
Re: Kick Start Bushes
Posted: Mon Apr 27, 2020 12:51 amThey usually just tap out with a punch inside one to the inside and outside one to the outside.
Re: Kick Start Bushes
Posted: Mon Apr 27, 2020 10:26 pmI think I used a socket from a socket set as a drift to ease the bushes out using a vice to push them out.
A bit of heat also helps. Done a few, and it was not as bad as it seemed it would be.
A bit of heat also helps. Done a few, and it was not as bad as it seemed it would be.
Re: Kick Start Bushes
Posted: Tue Apr 28, 2020 6:39 amKnowledge wrote:I think I used a socket from a socket set as a drift to ease the bushes out using a vice to push them out.
A bit of heat also helps. Done a few, and it was not as bad as it seemed it would be.
I’ve managed to get 1 out using a 17 mm deep socket but the inner most 1 I’ve not tried yet there not much purchase using the same socket I might see if I’ve an imperial size that’s slightly bigger.
Cheers Shane.