Page 1 of 1
Casa 185 running in speeds
Posted:
Wed Jun 24, 2020 9:36 pmby Pip110
Hi guys. I have put 260 miles on my new kit and there is a ride out on Sunday of around 60 miles, so far the max speed that I’ve done is About 35mph, could anyone suggest a max speed that I could take it to.
Thanks in advance for any help.
Re: Casa 185 running in speeds
Posted:
Wed Jun 24, 2020 10:08 pmby shane BBoys
Is it on a. Ew engine or an engine that has been run in before?
Cheers Shane.
Re: Casa 185 running in speeds
Posted:
Wed Jun 24, 2020 10:39 pmby CHRIS in MARGATE
35mph is not necessarily the correct way to run it in.
You need to keep the engine spinning freely without labouring it.
There is no reason you cannot rev it out a little more and run it up to 50mph + just so long as it is not under load.
Treat it like you would a geared racing bike. Your legs feel heavy so you change down.
Definitely use your gears on inclines and don't let it struggle.
35mph? Not achieving anything.
Re: Casa 185 running in speeds
Posted:
Thu Jun 25, 2020 7:24 amby Pip110
shane BBoys wrote:Is it on a. Ew engine or an engine that has been run in before?
Cheers Shane.
its a complete rebuild mate.
Re: Casa 185 running in speeds
Posted:
Thu Jun 25, 2020 8:59 amby HxPaul
I have two Casa185's with new cranks and new bearings and oil seals.I have done about 200miles taking it easy and when 200 was up I ran them as normal.
Re: Casa 185 running in speeds
Posted:
Thu Jun 25, 2020 9:03 amby dscscotty
Best way to run cylinder in is to use varying speeds, lots of heat cycles at varying rpm ranges over say a 300-400 ml period, just try not to hold it at single throttle position for long periods, increase speed gradually towards max rpm as running in mls are reducing,
good luck
Re: Casa 185 running in speeds
Posted:
Thu Jun 25, 2020 10:49 amby Pip110
HxPaul wrote:I have two Casa185's with new cranks and new bearings and oil seals.I have done about 200miles taking it easy and when 200 was up I ran them as normal.
THANKS MATE.
Re: Casa 185 running in speeds
Posted:
Thu Jun 25, 2020 10:50 amby Pip110
dscscotty wrote:Best way to run cylinder in is to use varying speeds, lots of heat cycles at varying rpm ranges over say a 300-400 ml period, just try not to hold it at single throttle position for long periods, increase speed gradually towards max rpm as running in mls are reducing,
good luck
MANY THANKS.
Re: Casa 185 running in speeds
Posted:
Thu Jun 25, 2020 4:52 pmby shane BBoys
dscscotty wrote:Best way to run cylinder in is to use varying speeds, lots of heat cycles at varying rpm ranges over say a 300-400 ml period, just try not to hold it at single throttle position for long periods, increase speed gradually towards max rpm as running in mls are reducing,
good luck
Totally agree, ride round all the estates winding everyone up turning left right right left using all the gears, up and down hill doing the same this way everything gets oiled and greased up!
Cheers Shane.