LCGB Forums

I'm looking for some good quality side protectors for my floorboards on a series 3
A lot of the ones I have seen are dimpled on the outside face where the fixings are on the inside
I would like to avoid these ones
Any leads gratefully received

Cheers
Mark

Mark

Placed in series 1/2/3 section where you may get more attention.

Cheers

Grazzi

Anyone help here??

These what you looking for ?

http://www.jockeys-boxenstop.de/shop/en/ersatzteile-zubehoer/trittbrettverbreiterungen/trittbrettverbreiterung-scootrs-serie-3-dl-gp.html



although for all of these you need to drill holes to attach them...

Kinda like those but not extensions
I've seen ones on scoot rs site
Costs as much to ship them as they cost in the first place lol
Cheers

Any good uk dealers

http://www.thescooterrepublic.co.uk/lam ... -6285.html

http://www.buzzsolomoto.co.uk/scooters- ... viewDetail

If you do decide to ship them in from scootRS DONT USE FEDEX , you get ripped off for " Import Duty " at a later date by them , they reckon that they pay it on your behalf and have you over a barrel ?? I know as I got skinned for a disc brake I got , cost me another £30

foremanbob wrote:These what you looking for ?

http://www.jockeys-boxenstop.de/shop/en/ersatzteile-zubehoer/trittbrettverbreiterungen/trittbrettverbreiterung-scootrs-serie-3-dl-gp.html



although for all of these you need to drill holes to attach them...

Apologies if this is high jacking this thread but I have a brand new set of extensions like this for sale. Never offered them up so I can't comment on fit etc. I want £30 plus post if anyone is interested. Please PM me.

Paul

TSR looks like a shout
Thanks for replys

Markpm wrote:TSR looks like a shout
Thanks for replys

hi Mark
i bought this type (but not from TSR), where the stud is welded on there will be a very small dimple, you cant prevent that during the welding process but it hardly notices.
personally i think that with the studs welded on it causes loads of grief when fitting. i removed the studs and most of the weld with a dremel then drilled 6mm holes and used 5mm bolts to give me a bit of leeway to make things easier to fit.