LCGB Forums

Posted: **Sun Mar 20, 2022 6:25 pm**

Just tried to install a new shaft, it went in easily, but there was no circlip groove for the plunger to rest on. I guess this was a machining error, unless I’m missing something? Unfortunately, I can’t remember where I got it from.

Posted: **Mon Mar 21, 2022 7:08 am**

I've had 2 cheap ones where the groove was so badly machined that it was no use, but never actually missing completely.

You're not mistaken, the part is wrong.

Posted: **Mon Mar 21, 2022 12:31 pm**

dickie wrote:I've had 2 cheap ones where the groove was so badly machined that it was no use, but never actually missing completely.

You're not mistaken, the part is wrong.

+1

LCGB Forums

Li SX Type kickstart Shaft Issue

Li SX Type kickstart Shaft Issue

Re: Li SX Type kickstart Shaft Issue

Re: Li SX Type kickstart Shaft Issue