LCGB Forums

Anyone else had bother with the Uni side casing been tight to get over the casing studs as if the holes in side casing are not in right spot. Tried on both a sil casing and a Spanish casing and both are tight.. Studs not central to holes in side casing.

gizmo wrote:Anyone else had bother with the Uni side casing been tight to get over the casing studs as if the holes in side casing are not in right spot. Tried on both a sil casing and a Spanish casing and both are tight.. Studs not central to holes in side casing.

Do you mean a uni engine casing ? When you say the other two are tight ?

Yep, had to open them up to get it drop over the studs.

On both i have fitted, on SIL casings.

Just went next drill size on all holes

Toddy wrote:

gizmo wrote:Anyone else had bother with the Uni side casing been tight to get over the casing studs as if the holes in side casing are not in right spot. Tried on both a sil casing and a Spanish casing and both are tight.. Studs not central to holes in side casing.

Do you mean a uni engine casing ? When you say the other two are tight ?

. Don't know how they fit on a Uni casing. Would hope they drop on perfect. Seeing Gaz has had same bother I presume they used a dodgy tape measure when they made mould. Thanks Gaz, I will do same

Mine went on a Spanish casing no problem.

Rich'

Rich Oswald wrote:Mine went on a Spanish casing no problem.

Rich'

. Strange isn't Rich how they can differ.