Squish
Posted: Thu Oct 16, 2014 10:05 amI am fitting a 150 barrell,head and piston to mt Li,will I need to check the squish clearence?
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
https://www.ilambretta.co.uk/forum/
Squish
https://www.ilambretta.co.uk/forum/viewtopic.php?f=10&t=1577
Page 1 of 1
Posted: Thu Oct 16, 2014 10:05 amRe: Squish
Posted: Thu Oct 16, 2014 12:54 pmI would check squish on every new top end i fitted.Your looking between 1.0mm - 1.5mm ideally.
Re: Squish
Posted: Thu Oct 16, 2014 2:13 pmThanks,will do.
Re: Squish
Posted: Thu Oct 16, 2014 2:19 pmDon't be too surprised if you are not able to get it below 1.5mm squish clearance because even without a head gasket fitted they rarely squish down to that clearance on standard parts.
Mark.
Mark.
Re: Squish
Posted: Thu Oct 16, 2014 9:43 pmOk,thanks for the info.