LCGB Forums

The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com

Skip to content

Big end

Technical help for Series one, two and three Lambrettas. Models include the Li, Li Special, TV, SX, GP, Serveta and API/SIL models
Post a reply

Big end

Postby Wack » Mon Nov 17, 2014 8:22 pm

Is it possible to buy a big end bearing to fit an Innocenti LI/SX crank with the stepped pin? I've searched a few dealers and bearing makers but drawn a blank. The bearing is 22.85/28.85/13.5 mm.
Last edited by Wack on Tue Nov 18, 2014 6:33 pm, edited 1 time in total.
Wack
 
Posts: 737
Joined: Sat May 31, 2014 7:11 pm
Top

Re: Big end

Postby dscscotty » Tue Nov 18, 2014 2:14 am

Try AF Rayspeed?
dscscotty
 
Posts: 718
Joined: Fri May 30, 2014 7:42 pm
Top

Re: Big end

Postby MickYork » Tue Nov 18, 2014 8:31 am

Martin at Chiselspeed should be able to help.
MickYork
 
Posts: 1476
Joined: Sun Jun 01, 2014 8:37 am
Top

Re: Big end

Postby Wack » Tue Nov 18, 2014 6:32 pm

Thanks I'll try them.
Wack
 
Posts: 737
Joined: Sat May 31, 2014 7:11 pm
Top
Post a reply

Return to Series 1, 2 & 3

Who is online

Users browsing this forum: No registered users and 20 guests

Powered by phpBB® Forum Software © phpBB Group