LCGB Forums

Hi

I have a series 2 li125 and I am trying to source a replacement or original kickstart lever for it.

All the replacements never seem to match the originals in the fact that they finish level or below the footboard.

I am after one that finishes above the footboard as the original. Anyone know who sells a quality matching replacement? Or have an original for sale.

Thanks

Try contacting Buzzsolomoto in Halifax.....

foremanbob wrote:Try contacting Buzzsolomoto in Halifax.....

Ive used Antonys Kicstarts the Series 2 to suit a Series 3 engine with the longer plate on to touch the stop very good quality

you may have to adjust the kickstart ramp or replace the peg that holds the kickstart piston, they do wear allowing the pedal up.
slight misalignment can be rectified by bending the plate on the kickstart up or down, on the Vietnamese ones, ( scootrs/ sterling, ) which I rate over indian or so called Italian ones which I doubt you could move! but look terrible

I bought an original one and doubled its cost by having it re chromed fitted and looked the bollox within a couple of days it bent lower and in to scrape the runner. Soft as cheese but looked good
I have a Buzz one now and its great so yet another thumbs up