it's an indian casing cos it has the extra strengthening webs for the engine mounts but has the innocenti stamping as well, i've not seen this before.
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
engine casing stamping
4 posts
• Page 1 of 1
engine casing stamping
by peejay » Thu Dec 25, 2014 12:08 pm
a mate is repairing this 200 casing :
it's an indian casing cos it has the extra strengthening webs for the engine mounts but has the innocenti stamping as well, i've not seen this before.
it's an indian casing cos it has the extra strengthening webs for the engine mounts but has the innocenti stamping as well, i've not seen this before.
- peejay
- Posts: 743
- Joined: Mon Jun 09, 2014 9:07 am
- Location: New Forest, Hants.
Re: engine casing stamping
by Jono » Thu Dec 25, 2014 12:28 pm
Be interested in replies as my spare engine also has the exact same markings . Had assumed it was a SIL Indian with a left over innocenti casting mark left in tooling.
Jono
Jono
- Jono
- Posts: 96
- Joined: Sat May 31, 2014 6:27 pm
Re: engine casing stamping
by bazza3004 » Thu Dec 25, 2014 2:24 pm
My casing is stamped the same i assume the mold has the innocenti logo cast in it and sil just add there own logo once cast. I could be wrong though.
- bazza3004
- Posts: 159
- Joined: Sat May 31, 2014 3:58 pm
Re: engine casing stamping
by rossclark » Fri Dec 26, 2014 9:18 pm
+1 mine is much the same, though an earlier casing than that. Also has an innocenti cast inside behind the chain adjuster plates.
-
rossclark - Posts: 2855
- Joined: Fri May 30, 2014 11:23 pm
- Location: Lanarkshire
4 posts
• Page 1 of 1
Who is online
Users browsing this forum: No registered users and 38 guests