Bridge piece
Posted: Sun Mar 29, 2015 4:42 pmAre series 1 bridge pieces different to series 2 and 3?
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
https://www.ilambretta.co.uk/forum/
Bridge piece
https://www.ilambretta.co.uk/forum/viewtopic.php?f=10&t=2908
Page 1 of 1
Posted: Sun Mar 29, 2015 4:42 pmRe: Bridge piece
Posted: Sun Mar 29, 2015 4:51 pmNo just different to Series III.
Re: Bridge piece
Posted: Sun Mar 29, 2015 4:59 pmJust come to fit a bridge piece on my series 1, it fits ok below the tool box but have a sizeable gap at the front between the legsheilds, I must have a series 3.
Re: Bridge piece
Posted: Sun Mar 29, 2015 6:12 pmI have the same gap on my Spanish Series 2 and I'm sure it's the original bridge 
Re: Bridge piece
Posted: Sun Mar 29, 2015 8:00 pms1/2 and 3 are very different .
I bought a remade S2 and it fit like crap on my indian frame (Lamby 150) and legshields (API)
I did a bit of reshaping and did nt use the correct rubbers - I used a toolbox door trim on the back and a thick profile rubber I got off ebay to take up the gap. I also added some trim the edges where the bridge rests on the rear footboards
I`m happy with it now its finished
if you look closely on this photo you can see what I did
good luck
I bought a remade S2 and it fit like crap on my indian frame (Lamby 150) and legshields (API)
I did a bit of reshaping and did nt use the correct rubbers - I used a toolbox door trim on the back and a thick profile rubber I got off ebay to take up the gap. I also added some trim the edges where the bridge rests on the rear footboards
I`m happy with it now its finished
if you look closely on this photo you can see what I did
good luck