LCGB Forums

I have just fitted a 13ltr tank to a gp 200 with 28 mm carb and was wondering is it best to leave the tool box out cause there's not much room for any cables etc

toolbox can stay. I agree there's not much room but it's adequate for routing the cables. sometimes a 90 degree elbow out of the carb' can help.

When you say 90 degrees is that the manifold your talking about

No, not the manifold the outer throttle and choke cable. A 90 degree elbow helps send them in the correct direction as opposed to straight up.

here you can see its a tight fit but no problem . to get an air filter in we had to cut 70mm square out of toolbox corner and mod panel alls good now even has LTH reedvalve its just got a longish throttle cable and fits between A64yorkie

A64yorkie wrote:

modtboxairfilter.jpg

here you can see its a tight fit but no problem . to get an air filter in we had to cut 70mm square out of toolbox corner and mod panel alls good now even has LTH reedvalve its just got a longish throttle cable and fits between A64yorkie

Why not just have the filter horizontal pointing toward the rear of the scooter?

Rich'

because of all crap and dust at lower level . also may interfere with air cooling

I would take it out and fit a legshield box.Just as I am doing