Page 1 of 1
fitting front dampers to my gp150
Posted:
Thu Jul 16, 2015 9:44 pmby kennystag
Hi All
I am fitting escort shockers to my GP150. Can anybody tell me what the distance between the 2 bolt holes on the shocker should be to fit to the forks
Cheers
Stag
Re: fitting front dampers to my gp150
Posted:
Fri Jul 17, 2015 5:07 pmby CambTim
have a look at Camb Lams site on welding brackets for dampeners. They tell you where to weld them on distance etc.
Re: fitting front dampers to my gp150
Posted:
Fri Jul 17, 2015 8:17 pmby Norrie Bodge
Re: fitting front dampers to my gp150
Posted:
Wed Jul 22, 2015 5:13 pmby kennystag
Hi thanks,
Is it 10 inches from the top eye bolt hole to the bottom eyes bolt hole on the shocker, can anybody help with this, I am using Escort shockers
Cheers
Stags
Re: fitting front dampers to my gp150
Posted:
Wed Jul 22, 2015 7:53 pmby HxPaul
The top mount should be welded/bolted in the case of bolt on brackets, just below the fork stop indentation.If the fork link is at its lowest point and the shocker fully extended,then the top bracket should be attached 10mm lower than the fullest extent of the shocker, which gives the shocker enough travel.