Page 1 of 1
Jig
Posted:
Thu Aug 27, 2015 12:37 pmby daniel whiteley
So ... I'm in Sheffield , where is the closest place to get my frame and forks put on the jig for checking , I think the forks are fine but may as well get them checked at same time as the frame has been dropped on the rear of the loop and had a knock on front support struts and needs a quick mount on jig
Mike Phoenix is in Manchester but is there anyone closer ? Does Jason at absolutely scooters do it or is there anyone recommended closer to Sheffield
Cheers
Re: Jig
Posted:
Thu Aug 27, 2015 1:06 pmby HxPaul
Startright motorcycles,Hunslet Road,Leeds is the only one I can think of that has a frame jig.No doubt someone will know somewhere closer.
Re: Jig
Posted:
Thu Aug 27, 2015 2:30 pmby Rich Oswald
HxPaul wrote:Startright motorcycles,Hunslet Road,Leeds is the only one I can think of that has a frame jig.No doubt someone will know somewhere closer.
Didn't know that and it's my neck of the woods! Do they know about Lambretta's though?
Rich'
Re: Jig
Posted:
Thu Aug 27, 2015 5:07 pmby HxPaul
They have a motoliner frame jig,they also sell and repair scooters,but I dont know if they know about Lambretta's.
Re: Jig
Posted:
Thu Aug 27, 2015 9:00 pmby Knowledge
Sheffield to Manchester? What's the problem? I drove from Ipswich to the Lake District to get a small frame Vespa checked. When I got there, the frame was found to be straight.
Ho hum. Nice scenery.
Good luck with your search.
Re: Jig
Posted:
Thu Aug 27, 2015 9:35 pmby daniel whiteley
Knowledge wrote:Sheffield to Manchester? What's the problem? I drove from Ipswich to the Lake District to get a small frame Vespa checked. When I got there, the frame was found to be straight.
Ho hum. Nice scenery.
Good luck with your search.
The timeframe of having 5 kids one being a toddler and the Mrs working , it's not that far of a drive just over an hr it's when !
Re: Jig
Posted:
Fri Aug 28, 2015 11:45 amby Rich Oswald
HxPaul wrote:They have a motoliner frame jig,they also sell and repair scooters,but I dont know if they know about Lambretta's.
As I say Paul, it's in my work area and pass regularly and even visit them on a job but never ever seen a Lambretta there either for repair or sale,
Rich'
Re: Jig
Posted:
Sun Feb 21, 2016 7:02 pmby daniel whiteley
managed to get it over to mike pheonix , cant recommend him enough nice bloke makes a good cuppa as well
Re: Jig
Posted:
Sun Feb 21, 2016 10:17 pmby Shaun
daniel whiteley wrote:managed to get it over to mike pheonix , cant recommend him enough nice bloke makes a good cuppa as well
Thats nice, but what was the outcome of the frame, bent or not??
Just curious
Re: Jig
Posted:
Mon Feb 22, 2016 7:14 amby Toddy
