LCGB Forums

Posted: **Mon Aug 31, 2015 7:22 pm**

Hi,
I have a series 3 Li 150 and wondered if anyone knows if there is a specific torque setting for the screws that secure the Kick start ramp plate. I cant find any information for this. Thanks in advance.

Posted: **Mon Aug 31, 2015 7:25 pm**

Not every bolt has a torque setting. Just tighten it up until it is tight.

(I don't own a torque wrench. They are not an essential tool)

Posted: **Mon Aug 31, 2015 8:10 pm**

It has three M6 bolts,5NM minimum on each bolt and you'll be fine.

LCGB Forums

Kickstart ramp torque settings

Kickstart ramp torque settings

Re: Kickstart ramp torque settings

Re: Kickstart ramp torque settings