LCGB Forums

I've searched the official Lambretta workshop tools list,this one is not listed,in fact all the original tools have codes with 5 digits only.
Does anyone have any idea what kind of use this tool could have in the Lambretta world?
I found it inside a pack of original workshop tools.

Hi,
It is a bearing or hub puller.
Cheers
Stag

kennystag wrote:Hi,
It is a bearing or hub puller.
Cheers
Stag

I was thinking the same, crank inner race removal??

colin

Non Lambretta generic bearing puller?

Adam_Winstone wrote:Non Lambretta generic bearing puller?

Probably

coaster wrote:

kennystag wrote:Hi,
It is a bearing or hub puller.
Cheers
Stag

I was thinking the same, crank inner race removal??

colin

Not long enough,
I have another longer generic that could be used for the crank inner,plus the original workshop tool.

Thank you guys,it can be a Vethpa tool as the guy that I took it from was also building scooters from the other brand

is it an early clutch spider remover?

It could be for an earlier model Lambretta. The legs near the jaw is specially shaped to fit something, maybe a gear or plate. It's also be 'modified' for use on something else.

Thank you again guys ,
it must not be a Lambretta tool all the official codes are with 5 digits.

hullygully wrote:is it an early clutch spider remover?

The code is 78013



This is the price list from a large selection of original workshop tools,
I found it on an Italian scooter forum.

Just took two pics to show,
the original workshop tool for the crank inner race removal left,a generic puller at the middle and the unknown generic puller right.

Would it fit between the two rows of teeth on a front sprocket?

It fits between the two rows of 14T and 15T front sprockets but it cannot be used as an extractor because it is too short.

I've searched on the web and found that this kind of tool is called Pitman Arm Puller,
I don't know if it can have any use on 3 wheelers.

15T



16T



19T



15T



18T