series 1 cases
Posted: Thu Nov 26, 2015 3:09 pmAnyone know if there's enough meat on a 1959 series1 150 casing to get a 200 block conversion done?
Check out this post.
http://scooterotica.co/forum/viewtopic. ... cf2d5f8777
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
https://www.ilambretta.co.uk/forum/
series 1 cases
https://www.ilambretta.co.uk/forum/viewtopic.php?f=10&t=4665
Page 1 of 1
Posted: Thu Nov 26, 2015 3:09 pmRe: series 1 cases
Posted: Thu Nov 26, 2015 3:54 pmRe: series 1 cases
Posted: Thu Nov 26, 2015 4:25 pmThat's mine in the aforementioned thread with the two exhaust studs enlarged.
Re: series 1 cases
Posted: Thu Nov 26, 2015 4:27 pmThanks.
Looks like it's possible but could be expensive.
I've got a couple of stage 4 Indian 200 barrels on the shelf and a mugello 225 so thought it might be cheaper to convert the cases rather than buy an rt or mugello small block kit.
Looks like it's possible but could be expensive.
I've got a couple of stage 4 Indian 200 barrels on the shelf and a mugello 225 so thought it might be cheaper to convert the cases rather than buy an rt or mugello small block kit.
Re: series 1 cases
Posted: Thu Nov 26, 2015 5:41 pmMarty
It wasn't when I got it done 2012 - cost me £180 for the lot - including the vapour blasting.
I think it's a tad more now with a long lead time.
It wasn't when I got it done 2012 - cost me £180 for the lot - including the vapour blasting.
I think it's a tad more now with a long lead time.
Re: series 1 cases
Posted: Thu Nov 26, 2015 7:02 pmThink Mike Phoenix charges about £150 for the welding/machining.