Page 1 of 1
Rev counter
Posted:
Sat Jun 28, 2014 5:02 pmby Rushy
Hi has anyone fitted a Rev counter to a lambretta, if so where can i get one that will work. got one looked great but i could not get it to work.
any ideas
rushy
Re: Rev counter
Posted:
Sat Jun 28, 2014 5:17 pmby Rich Oswald
I have just fitted one of these, cheap and cheerful and works a treat :-
http://www.lambrettaspares.com/spares/s ... u0818.htmlRich'
Re: Rev counter
Posted:
Sun Jun 29, 2014 12:08 pmby gaz_powell
Re: Rev counter
Posted:
Sun Jun 29, 2014 4:05 pmby roadrunnerian
sip speedo on mine
Re: Rev counter
Posted:
Sun Jun 29, 2014 6:12 pmby Rushy
Thanks for the replys . It has given me some ideas
Rushy
Re: Rev counter
Posted:
Sun Jun 29, 2014 9:37 pmby rossclark
How do you find that one Gaz?
I bought one for the pig but not got round to fitting it yet.
Re: Rev counter
Posted:
Mon Jun 30, 2014 7:46 amby CHRIS in MARGATE
I bought one of these little gizmos over a year ago on ebay for about a tenner. Simplicity in itself to fit; about 6 windings around HT lead near plug cap and run the wire through frame to back of tacho; no power connections and it works ! And it works brilliantly. I have bought some rubbish in my time but trust me this is just fantastic. Very responsive and when engine not running shows permanent display of engine run time.
Re: Rev counter
Posted:
Mon Jun 30, 2014 8:38 amby Digger
CHRIS in MARGATE wrote:I bought one of these little gizmos over a year ago on ebay for about a tenner. Simplicity in itself to fit; about 6 windings around HT lead near plug cap and run the wire through frame to back of tacho; no power connections and it works ! And it works brilliantly. I have bought some rubbish in my time but trust me this is just fantastic. Very responsive and when engine not running shows permanent display of engine run time.
Which one was it?
Re: Rev counter
Posted:
Mon Jun 30, 2014 8:53 amby CHRIS in MARGATE
Like a lot of Chinese sourced stuff, no distinguishable name. Slightly smaller than a matchbox and very unassuming. On ebay it was stamped something like single cylinder 2 stroke cycle. If I get time I will take photo.
Re: Rev counter
Posted:
Mon Jun 30, 2014 7:26 pmby gaz_powell
I ve got the exact one on the link and find them decent.
simple to fit as Chris said and works a treat - they are not in real time they are a fraction behind
just got another one my new build - got one on the vespa aswell
get it fitted and see what you think - it`ll only take 10 minutes
what good about these is they come with a decent length of cable some similar ones have a short wire