series3 floor runners
Posted: Wed Jun 15, 2016 8:19 pmdoes anyone know good way to fit the rubber into the channel i have tried soaking in hot water and putting grease in Channel to no avail wayne
LCGB Forums
The ability to post messages is restricted to LCGB members. Any questions contact us at lcgbadmin@googlemail.com
https://www.ilambretta.co.uk/forum/
series3 floor runners
https://www.ilambretta.co.uk/forum/viewtopic.php?f=10&t=6097
Page 1 of 1
Posted: Wed Jun 15, 2016 8:19 pmRe: series3 floor runners
Posted: Wed Jun 15, 2016 8:33 pmBoiling hot water is the clue and it also depends on the quality of the rubbers. Some cheaper ones are pretty hard, less flexible and harder to fit.
Re: series3 floor runners
Posted: Wed Jun 15, 2016 8:38 pmHi do you slide them up or press them in when hot
Re: series3 floor runners
Posted: Wed Jun 15, 2016 8:53 pmPut one side in and push the other side in with a flat headed screwdriver
Re: series3 floor runners
Posted: Wed Jun 15, 2016 9:14 pmThanks mate it works i struggled with other side pulling them up with pliers grease, sweat and swear words