LCGB Forums

Hi all,
I'm after some help, I was changing my clutch springs the other day, I noticed while I was lying on my back that the rear hub had some movement, had a play with it, felt like on a car when the bearing is out..

So, hub off etc... lay shaft is fine, bearing seems perfect, so the only other assumption I can make, is the hub cone..
I brought the engine as a going concern, the hub and cone were in a box.
So my question is..., having looked through sticky's book, how do I measure the cone against the hub to make sure it's the right one for the hub.

How can something so simple be such a bas#*×@

Thanks in advance for your help

Trevor

I won't ask why you were lying on the floor

I have exactly the same problem with my S3 so I'll be following this closely.
My hub has quite a wobble but no lateral movement, so like you I'm guessing its the cone thats worn.

johnnyXS wrote::lol: I won't ask why you were lying on the floor

Shock of the cost

most bills are best taken lying down

I'll keep my eye on this thread and see what you find .