Page 1 of 1
Tool box rubber alternatives
Posted:
Fri Feb 17, 2017 7:54 pmby Knowledge
The proper toolbox (underseat) rubber is a pain to fit and for my special application, far too thick.
Can anyone recommend a slimline rubber for this location?
Re: Tool box rubber alternatives
Posted:
Fri Feb 17, 2017 8:09 pmby gaz_powell
On all my twin tank conversions I've used a sticky back reinforced rubber strip stuck to the inside of the frame - haven't got a clue where it came from and non left - it was a single sided glazing tape I think.
Re: Tool box rubber alternatives
Posted:
Fri Feb 17, 2017 9:30 pmby shane BBoys
Could that be something like the fridge guys use?
Armourflex tape!!
Re: Tool box rubber alternatives
Posted:
Fri Feb 17, 2017 10:52 pmby Warkton Tornado No.1
Knowledge wrote:The proper toolbox (underseat) rubber is a pain to fit and for my special application, far too thick.
Can anyone recommend a slimline rubber for this location?
I can't say I've needed to find anything like it, but a quick search on t'internet found this which has a large, varied choice:
http://www.deltarubber.co.uk/pdfs/extru ... alogue.pdf
Re: Tool box rubber alternatives
Posted:
Fri Feb 17, 2017 11:20 pmby Wack
Try the old car door push on trim.