LCGB Forums

Hi Guys

I am after the rubber that goes round on the legshield toolbox, I have got the correct rubber which when I did the dry build fitted perfectly, but since I had the spray done this no longer fits as perfect down the sides!

I have since been informed this is due to the legshields trying to bend ' outwards' when placed in the oven for drying!

All I know was fine in dry build now S*&^. Looked on the famous auction site on web, but cannot find the right stuff, want same profile just deeper rubber!

Regards

Last one I got from Rayspeed. It was quite a thick chunky one. Think beedspeed have them too

Hi Gizmo

I will check with Beedys at the weekend with the one I have now, as I believe this is the ' thicker one' that Beedys sell.

Regards.

Hi all,

I could also do with a thicker type legshield toolbox rubber for a fibreglass one which is a lot thicker than the steel type the latest rubber i got just will not go on and seal right any suggestions as to where? Thanks